Electronics Line Penta XL series Manuel d'installation télécharger pdf (Page 11)

-11-

Chapter Three: System Operation

3.1: General

Using any one of the three LED keypads that can be installed with the system, you can

perform all operation and programming functions. This section offers a complete

explanation of the keypad functions and of the LED display, incorporating a summary of

command codes used in system operation.

3.2: Keypad Layout

The following diagram shows the keypad layout for the 3104 Plus keypad for use with the

Penta Plus XL control panel. The layout of the 3104 keypad, supported by Penta XL

control panels, is identical except for the number of zone indicators on the LED display.

READY1 234

6 7 8 SYSTEM

Figure 3.1: 3104 Plus Keypad Layout

The numeric keypad enables you to operate and program the system. Additionally, three

distress keys enable the user to send one of three individual distress signals to the

central station - see 3.5: Distress Keys for further information.

LED Display

Zone Indicators: The zone indicator LEDs display zone status. The corresponding LED

lights up if a zone is open. If a zone is bypassed the corresponding LED flashes. If an

alarm occurs when the system is armed, the corresponding LED flashes until the system

is disarmed.

READY: The Ready LED lights up to indicate that there are no open zones or tamper

conditions and the system is ready to be armed.

SYSTEM: The System LED flashes to indicate that new events have been recorded in

one of the logs and when displaying additional system information such as programming

mode or bypass mode.

Status

Indicators

Numeric

Keypad

Buzzer

Distress Keys

Status

Indicators

Zone

Indicators

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 32 33

Pas de commentaire

Electronics Line Penta XL series Manuel d'installation Page 11