Electronics Line 3208GLD Manuel d'utilisateur télécharger pdf (Page 35)

ADDRESSES 296-310: EVENT & MESSAGE ROUTING

Event code messages can be routed in several ways. Each telephone number can be set as a primary,

back-up or duplicate number for a specific group of events. The control panel can also be programmed

not to dial a certain telephone number for certain events. A primary number is the first number the

control panel dials when an event occurs. If the control panel is unsuccessful in dialing the primary

number, the back-up number is dialed. A duplicate number is used to report the same event to several

locations and is dialed only after a successful transmission has been made to the primary number.

Routing also determines whether messages are entered in the log, whether the bell is activated and

which bell pattern is sounded.

296-298 Message routing for burglary alarm messages

(alarm, alarm restore, holdup, keypad emergency, police)

296 Message routing for burglary alarms, telephone numbers 4 and 3

Telephone #4

First digit value:

0 - Do not call this telephone number

1 - Primary telephone number

2 - Duplicate telephone number

3 - Backup telephone number

Note: If the Follow-me feature is used, define this number as a duplicate telephone

number.

Telephone #3

Second digit value:

0 - Do not call this telephone number

1 - Primary telephone number

2 - Duplicate telephone number

3 - Backup telephone number

297 Message routing for burglary alarms, telephone numbers 2 and 1

Telephone #2

First digit value:

0 - Do not call this telephone number

1 - Primary telephone number

2 - Duplicate telephone number

3 - Backup telephone number

Telephone #1

Second digit value:

0 - Do not call this telephone number

1 - Primary telephone number

2 - Duplicate telephone number

3 - Backup telephone number

298 Bell Delay, Log Entry and Bell Activation for burglary alarms Select from the following

options to set the 20 second bell delay, log entry and bell activation for burglary alarms.

Bell Delay and Log Entry

First digit value:

0 – No bell delay, no log

1 – Bell delay, no log

8 – No bell delay, log

9 – Bell delay, log

Bell Activation

Second digit value:

0 – No bell

1 – Bell pattern 1

2 – Bell pattern 2

3 – Steady bell

Note: Pulsed signals are available for special alarm types.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 50 51

Commentaires sur ces manuels

Pas de commentaire

Electronics Line 3208GLD Manuel d'utilisateur Page 35

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Electronics Line 3208GLD