Electronics Line 3208GLD Manuel d'utilisateur télécharger pdf (Page 19)

3.9: Event Log

The event log records the last 100 events the system has undergone. The event log uses the FIFO (first in, first

out) method. Once the log is full, the oldest event will automatically be erased. The event log can only be

viewed with the LCD keypad.

View Event Log

To view the event log:

1. From the View/Log menu select View Log or press SELECT 6, 1.

2. Enter an authorized user code.

3. Scroll through the log by pressing the MENU/NEXT key. The events are displayed starting with the most

recent event registered in the log.

4. Press AWAY to exit the log.

The following table shows examples of typical event log displays.

Event Display

Day 23 in month, time 12:45, alarm from zone 2,

Bathroom

23 12:45 ALARM

BATHROOM, 02

Day 23 in month, time 12:50, system 1 was armed

(perimeter) by user 11.

23 12:50 STAY

SYS.1 BY USER 11

System message: Last message was successfully sent

to the central station.

23 13:56 SYSTEM

REPORT SENT

Log viewing completed. *** END OF LOG ***

Clear Event Log

To clear the log:

1. From the View/Log menu, select Clear Log or press SELECT 6, 2.

2. Enter an authorized user code; the log is erased and the message “***END OF LOG***” is displayed. Clear

Log also causes the Armed LED to stop flashing and zone in alarm messages to be cleared.

3.10: System Partitioning

The Summit 3208GLD can be operated in partitioned mode where the system is separated into a maximum of

four sub-systems. A sub-system is created when at least one zone has been assigned to it. The following

section describes how certain elements of the system are affected by system partitioning.

Zones

Each zone can be assigned to a one of the four sub-systems. A common zone is assigned to all sub-systems

and will only be armed in the event that all systems are armed.

User Codes

User codes are assigned to any sub-system or to the entire system during user code programming. For more

information on the programming of user codes refer to page 18.

Keypad Display

The keypad can display either the entire system or a specific sub-system. This is programmed at parameter

addresses 132 - 139.

Arming & Disarming

Pressing STAY or AWAY on a keypad assigned to a specific sub-system arms only that sub-system. Entering a

user code assigned to a specific sub-system arms the system to which the user code has been assigned. To

disarm a sub-system, the user code entered must be assigned to either that sub-system or to all systems. All

arming methods are available for each sub-system.

Note: If the user code entered is assigned to all systems, the panel asks which system to arm. Entering

System 5 arms all the sub-systems that are ready.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 50 51

Commentaires sur ces manuels

Pas de commentaire

Electronics Line 3208GLD Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Electronics Line 3208GLD