Electronics Line PENTA Manuel d'utilisateur télécharger pdf (Page 5)

-5-

3.2: Command Codes

The security system is operated by entering command codes on the numeric keypad. A

command is executed by pressing the ‘4‘ button followed by the corresponding

command number. In some cases, a valid user code is also required. The following is a

summary of the command codes used in system operation.

Quick Arm

45 + (User Code 1)

Program User Codes

41 + (User Code)

Bypass Mode

Zone Chime

Emergency/Trouble

Event Log

48 + (User Code)

Forced Arming

Zone Alarm

Event Log

49 + (User Code)

Stay Arming

441

442 + (User Code 1)

Bell/LED Test

Walk Test

ENTER 1 + (User Code 1)

Stop Communications

3.3: Keypad Tones

The keypad sounds various tones to indicate the following:

• Short Beep – Confirmation of each keystroke

• Half Second Beep – Acknowledgement of a successful command entry

• Low Beep – Rejection of an illegal command entry

• Continuous Beeps – Entry/Exit Delay in progress

3.4: User Codes

User codes are the codes that grant you access to various system operations, such as

arming and disarming. Each user code is four digits long. Of the four user codes, only

User Code 1 has the authorization to program other user codes. The default code for

User 1 is ‘1111’. This default value must be changed immediately to prevent

unauthorized access to your system.

To program user codes 1-4:

1. Press 4, 5.

2. Enter User Code 1; the Armed and System indicators flash and the zone

indicators indicate the programming status of each user code as follows:

OFF:

NOT PROGRAMMED

ON:

PROGRAMMED

FLASHING:

CURRENTLY BEING PROGRAMMED

3. Enter the number of the code to be changed (1-4); the requested zone indicator

flashes.

4. Enter the new user code; the indicator stops flashing.

Note: If the new code is identical to an existing user code, an error tone will be

sounded and the new code will not be accepted.

To erase a user code:

1. Press 4, 5.

2. Enter User Code 1.

3. Enter the number of the code to be erased (1-4); the requested zone indicator

flashes.

4. Enter 4, 4, 4, 4; the indicator stops flashing and the code is erased.

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire

Electronics Line PENTA Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Electronics Line PENTA